Hi-Def Plasma Metal Cutting
Our Dynamic WaterJet offers superior edge quality compared to other production cutting methods. Our Dynamic WaterJet eliminates the need for expensive secondary operations that remove HAZ or clean an edge prior to joining.
Water jet metal cutting
For example, plasma and laser leverage vast amounts of heat to melt the material. Unfortunately, this process creates a heat-affected-zone (HAZ), a result that is suboptimal for many applications. HAZ may display different mechanical and chemical properties, depending on the material. For example, heat will lower the strength of strain-hardened materials, such as quarter hard stainless, at the site of cutting. When cutting precipitation-hardenable alloys (e.g., 4340, titanium 6-4 alloy), HAZ may change the strength of the material at the location of cutting, either making it harder or softer depending on prior treatment. Sometimes, the area also becomes sensitized and less resistant to corrosion.
Cutting metal with water
There is no heat transfer during waterjet cutting, ensuring a smooth final product that requires little to no finish preparation before use.
List of applications where waterjet cutting is recommended for metals:
Cut almost any alloy or tool steel
From metals like steel, aluminum, stainless and even tungsten carbide.
Wide range of thicknesses cut
From as thin as 0.018 inch to 4 inches, and even thicker material cuts are possible.
Intricate shapes in delicate materials
Cutting honeycomb items was a challenge, due to the thin sections.
Custom shims in stainless steel and exotic material
Need a custom metal gasket or shim cut in a hurry? Give us a call!
Blank cutting of parts for final machining
Blanks are repeatable from job to job as they are CNC cut. Let ourplasma do the rough machining.
Short run lots of sheet metal parts
One piece to many pieces, we will be glad to cut your material as fast as possible.
Converting plate stock to flat bars with sharp / crisp corners
Dynamic cutting head automatically offsets the cutting angle to compensate for taper. Nice clean and straight edges are the result.
60000 psi plus air and garnet cuts through just about anything! Cold Worked, aged or tempered, typically it doesn't increase the abrasive resistance.
Close tolerances, of plus or minus 5 thousandths of an inch (+/- 0.005"), are possible over the entire length of the part.
Cutting table is 6.5 feet x 13 feet
Pieces can be cut from sheets or plates as large as the table. Larger format allows for nesting of parts to achieve the best yields possible.
We allow input during the quoting phase to ensure that the part is not over specified. By allowing the customer to select multiple tolerances, or edge finishes on the part in various areas.
First Article Parts
By using our First Article cutting option, you can make sure that the part meets all the requirements before production cutting begins.